Ovulation Test Instructions

Before you begin

Read all the information in this pamphlet before performing the test. First, make sure you are familiar with the test kit contents shown above. Store at 35±86°F (2±30°C) in the sealed pouch, away from direct sunlight. Do not use after the expiration date stamped on the package.

Instructions

1. Open the sealed pouch, remove the Verséa™ Easy Lab Ovulation Test stick, and remove the protective cap. Perform the test right away after opening the pouch.

2. Turn the test stick so that the reading window is facing away from you, with the absorbent tip down, and hold the absorbent tip in your urine stream for 10 seconds. The test will not work properly if too little urine is absorbed or if urine is spilled into the reading window.

3. Replace the protective cap over the wet absorbent tip and leave the stick on a flat surface with the reading window facing up.

4. Read the result after 3 minutes. While you wait, you will see a pink color moving up the reading window. A pinkish-purple line will form in the control (upper) window to tell you the test is working correctly. Do not read after 10 minutes.

Alternate Procedure

1. Collect urine into a clean cup. Open the pouch and remove the test as above. Dip the absorbent tip of the stick at least halfway into the urine, for at least 10 seconds.

2. Replace the protective cap over the wet absorbent tip and leave the stick on a flat surface with the reading window facing upward.

3. Read the result after 3 minutes.

Results

Wait at least 3 minutes before reading your test.

Positive: If two lines are visible and the one in the Test Window is the same as or darker than the one in the Control Window, you will probably ovulate in 24±48 hours.

Negative: If the line in the Test Window is lighter than the line in the Control Window
or there is no line in the Test Window, no LH surge has been detected.

Invalid: If there is no line visible in the Control Window, the test did not work properly
and should be repeated. A Control line will always appear if the test worked properly